GT-P5210 - only download mode, not charging - Galaxy Tab 3 Q&A, Help & Troubleshooting

Hello!
I have a Samsung Tab 3 10.1 (GT-P5210), that is fully stock nothing happened. When trying to boot it up or put it into recovery mode - nothing happends. I can't get the Samsung logo to appear or anything. At first I thought the LCD was broke but when I put it in download mode the screen shows me everything going on.
I can't charge battery - input power: 5.1-5.2V and 0.00A.
So I can only put in download mode.
I tried reconnect battery cable, but without any effect.
What's wrong?

I,having same thing, i kept pushing button combos and plugging it in until it just starts charging. Took a few times. Get it to 100%full before you flash amything on tis device

Related

Galaxy Tab 3 NO Power, boot loops when plugged in. Otherwise nothing Video attached.

Hi all, I've been using XDA for years since the original O2 XDA's and I have never had to post anything as I've always found my solution. I'm hoping somebody can assist me with a problem I have on this stock galaxy tab 3.
The device was brought to me after being thrown down the stairs. I replaced the screen and built it back up,
Removed battery connector and reconnected = nothing happens
Press power = nothing happens
press download mode = nothing happens
press recovery mode = nothing happens
Plug USB into PC = nothing happens on PC or tablet
Plug in USB mains charger and it displays battery charging logo but it doesn't fill or animate the fill then it starts the samsung boot screen. It reboots and continues to do this constantly and never ends.
I've tried two batteries and both batteries work in another tab 3 but neither batteries changed how the device works.
Thank you for any advice in advanced!!
I just received a Tab 3 lite (SM-T110) for repair, it's having a similar problem.
It does automatically turn on when plugged into charger or computer.. It is stuck on a bootloop, requiesting a Kies recovery. It does reboot when given the three finger salute (center button, volume down, and power) - it will not enter recovery mode though - same firmware error message). The device is also full off or full on, no indication of it's it's recharging or no - let the battery run out, it's off - else it's on (does not turn on or off with power button). I don't have any info how it got into this state - most likely power loss during a firmware update, but haven't ruled out other possibilities (ie bad rooting job, a custom ROM upgrade went wrong, etc). I'm not 100% concerned about cause, but hopefully I can unbrick the thing.
Anyways, I loaded Kies onto my computer and put it into recovery mode and plugged it in - nothing. Exit the recovery mode of Kies, and all of a sudden the program goes nuts trying to connect and disconnect from the device. Hmm... Okay, disconnect it, uninstall Kies, install Kies3 and try again - same thing except it complains the device is too old when the program leaves recovery mode - but same thing otherwise - does not show up in recovery mode, connects and disconnects at huge rate when not in recovery mode....
Hmmm...
Now looking at the screen, it does indicate (in the upper left hand corner) that it's in ODIN mode... So my next step I figure I'll try ODIN (although I'm researching ODIN at the moment as I haven't used it before (never had to unbrick anything from Samsung prior to now).
Okay, that was painless - downloaded and installed ODIN 3.10.7, and then downloaded the latest firmware from Samsung, extracted the firmware, added it to ODIN's AP line, then hit start to push the latest firmware onto the tablet. Good as new again.

Samsung Galaxy Tab Pro 8.4 - Not charging/cant boot to recovery/cannot connect to PC

Hi Guys,
I have a problem with this device about years ago. As I'm playing Vainglory, my tab turned off instantly then after trying to turning it on again, nothing happens, I thought it just ran out of battery. I tried to charge it but only the charging battery icon shows up but it doesn't charge even if i left it overnight. I tried to access it's recovery mode but it bootloops only. BUT I can access the download mode easily but If I try to connect it to PC then boot it in download mode. It just die and bootloop. I know that only the download mode can help me on this. I just can't simply use odin/kies cause my device doesnt connect to PC. Tried to use different cables/Reseatting the battery but nothing happens.. Also, it only boots/respond when connected to a charger. Is this soft bricked?Please help... Thank You.

Unable to access download mode, bootlooping.

Hi,
After wiping /system on my Razer Phone, I tried to sideload an image, and the recovery crashed and the phone rebooted. Since, it has been restarting indefinitely, being on the Razer logo and the "Your device is insecure" message.
I have tried to hard shutdown the phone with power+volume up, then holding volume down and plugging the phone, but I was unable to get download mode working...
Volume up then plugging in the phone to my computer did not help either. Both volumes either.
If someone has an idea on how to get it into download mode, I'd really be grateful. Thanks.
Try power and up for nearly a min sounds stupid I know but forces a full full power down. Otherwise wait a few days for the battery to die then plug into pc with vol down held.
Tried both. I even opened the phone, unplugged the battery, then plugged it again to force a shutdown. It never got into download mode
What type of USB cable are you using?

Cannot boot into download mode

Hi everybody, yesterday I was playing with my old Galaxy A50 trying to install a custom rom unsuccessfully.
I repeated the procedure three times installing TWRP and then Havoc OS but every time I tried to reboot from TWRP to OS I was stuck at the warning screen saying that the phone bootloader was unlocked and booting into download mode to reflash TWRP was blocked as it showed "only official binaries can be installed" (yes I installed Samsung disabler but still).
Still I was able to get the phone into download mode and reinstall the stock firmware as it seemed to be the only way to install and boot TWRP.
But at 4th time repeating the process I got frustrated, shut down the computer and left the phone on the warning screen still connected to computer usb cable.
Then I got back and noticed the phone was off as the battery died.
Indeed the battery died, so I put the phone in charging and after it reached 100% I tried to boot into download mode again to reflash stock firmware.
But here's the strange thing, I cannot boot into download mode anymore as pressing vol up+vol down while connecting usb cable, shows the lightning charge logo for 5 secs and then reboots infinitely with the same pattern.
If I force reboot by pressing vol down+power it shows the Samsung logo with the warning below it, then skips to another screen with another warning suggesting to press power button to continue (which does nothing) and after a while reboots to samsung logo.
So it doesn't seem it is bricked, it looks more like a battery controller fault, so I tried to detach the battery flex from the board, hoping it would reset the controller but it's still the same.
Also I tried with the flex detached and still no download mode is possible.
Was the download mode somehow erased? (if it's even possible considering it's the motherboard firmware)
If you need photos, videos or even a call on zoom, Skype, webex I would be glad to show you
same i got the same problem i can't find nothing for this when i press volume up and down and put the otg cable its simply charges but it gets stuck on the logo image there's no way to fix this but the only way is to open the phone,change the emmc and put one from samsung,close the phone flash a custom rom and you are done.
If you can enter recovery, do it. As soon as your phone gets into it, select the power off variant and then try to enter the download mode.
It seems like you did not unlock the bootloader, did you?
The bootloader Is unlocked i can't enter in the recovery because the phone locks on charging logo and its fully charged but when i try without charger It doesn't start.

A70 stuck in samsung logo and declines port.

I rooted my Galaxy a70 using vbmeta,Twrp and magisk. All was going well. Suddenly my phone turned off and when I press power button its shows download mode .so I tried odin to flash but every time it fails.After many tries I realise that its port are not connecting to pc ,its only charging and my pc also can't detect my phone ..now when I connect the phone to pc its shows samsung logo.its also not showing the battery percentage .
(My pc is ok it have all driver installed and odin works)
Is there anyway to solve.
Thanks.
reboot pc just to be sure.
connect phone and pc
on the phone in download mode screen, hold vol down and power till screen goes blank immediately let go and hold vol up and down to boot back into download mode. the letting go when screen goes blank to holding up and down needs to be fast.
now once back in download mode, is odin showing port number?
also make sure your using odin 3.13.3
if still no go, try uninstalling samsung usb drivers, reboot then reinstall and try the process again.
When I put cable in my phone it directly shows the logo....
Its not showing the battery
I tested my another Samsung phone to be sure that my softwares are working. And it's working but when I put my A70 in. Nothing happened

Categories

Resources