Hi everyone, I was trying to disassemble my A50 because I had ruined my LCD when I violently dropped it and I wanted to take it upon myself to fix this damn thing. I saw that the frame's (?) front part had a crack on it, I presume from the aforementioned fall. I was wondering if I were to replace my LCD, would I need to get a whole frame with it, or if it's fine to just get an LCD without the frame.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Related
After countless of hours diagnosis and doing trial and error in order to rectify the faulty touchscreen issue where a certain part of the touchscreen area is not working. My solution for this problem is by putting a piece of paper or hard cardboard underneath the digitizer ribbon cable just after the connector.(refer the circle part in the picture below)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Hope it fix yours.
My brother who lives in Budapest had someone replace the battery they broke the fpc connectors when he got the phone back the screen wouldnt work so he called the guy who had run away and left him with three desolderd fpc i have someone who can replace them but i would need to buy the connectors ports
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Hello, I'm clumsy and destroyed my display by dropping my phone.
So I ordered a new display, removed the old one and connected the new display and everything worked. (With open case).
Then I was ready to glue the new display in, removed all the protective foil and suddenly the touchscreen is not working anymore.
Can someone give me a hint what the problem is?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
How should the small connector (Ground?, on the left side) should be attached to the inside of the phone?
Do I need a new screen or is the screen you actually touch when using the unit just a cover?
I had the unit out and when pushing it back in I must have pressed on the edge too hard and it cracked upwards
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
On most head units the outer glass is the capacitive touch glass while the actual screen is inside. That looks like the outer glass that is cracked.
Hi Guys, it's been a while since i have started seeing that white patch on my phone's display. Sometimes it goes all the way up and covers about 3/4 of screen. But here's a thing, when i give a lil bit heat to display (with heatgun, blower or whatever) these lines and patches just disappear. Is this a hardware issue or something else? Please help
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}