Troubles with connection - HTC Excalibur

from yesterday my phone stop connecting with my Mobile Provider.I am didnt drop it or install new software during this time.I try to change my SIM card with new one and with SIM from other Provider but the problem still exist. Today i try first reset and after that I install wm v_6.5 set up all options for my country ,again try with 3 different SIM but...
i still can't use it like phone.Can't connect to my Operator.
thx in advance for advices and help

Did you run the connection setup in the accessories folder?

Did you run the connection setup in the accessories folder?

Did you run the connection setup in the accessories folder?

I have the same problem. Tried to install different ROM`s but it seems that phone connectivity is gone. It is not able to connect to cellular network (searching connection forever) but BT and WIFI works fine as well as all other stuff. This is not an issue with location since I tried it in different places where other phones working fine and shows excelent signal.

Odd, my data connection suddenly quit yesterday as well (had the EVO series ROM loaded). I loaded on the new build from today and it worked for a few, but then stopped again.
Any ideas? I can make/receive phone calls, but the data connection is no longer responding.

nobody know ???
hmm,nobody know how to dissolve this problem or nobody care ??
just wondering what i can do with my phone - coz it is unuseless now.
As i read - i'm not only one with this troubles.
p.s. - never syncro your phone with " GoodSync " program

Taxed out i had another p4000 which would connect to data then disconnect.
HTC 621 true Microsoft verson.

bump for this topic coz i am loved in my phone and still can't use it
i did the same like description from this topic
http://forum.xda-developers.com/showthread.php?t=535459

Just out of curosity what is shown in the "Access Point" under Connections/GPRS for your data settings?
try internet2.voicestream.com or epc.tmobile.com

Related

Edge/3G Problem (Cingular)

As of a few days ago my EDGE/3G connection stopped connecting. All the settings are correct, even re-entered them manually a few times, still get the 'cannot connect' error, even though signal strength is more than adequate.
Even stranger, however, is when I use a .cab to automatically inject the settings everything works fine for a matter of minutes, then the connection problems resume.
Running CUSTEL's 2.5, problem started a couple weeks after the flash, and the only thing I have installed since is the Palm Threader, which makes no sense that it would be the culprit.
So this is not a WM6 issue correct? Its an issue with you messing up your connection settings... WRONG THREAD
Pardon me, it is not an issue with my settings, as I said in the first post even if I use a Settings Cab to inject them the data connection still quits after a few minutes even if i have not changed any settings. This never happend with WM5 and it is the first time it's happened with WM6, I would take it into a Cingular store, but I'm concerned the reps would see WM6 and just nullify any support.
Need more info to diagnose. What apps are you experiencing the problem in? Which cingular plan are you on? Which cab did you use to inject the settings.
There is some problem with the lastest wm6 roms for using cingular and pie if you are on the isp plan. Make sure your DNS is hard coded and it will fix it if its the same problem. Seach the forums and like most probs you will find your answer.
connection problems
just to let you know I have been having trouble connecting I connect and then get kicked off I had to use the isp connection settings my friend works for them and he told me it had to do with towers and the cingular and att thing
Edge and 3G
cingy had issues today had the same issue earlier all better now
yeah pure data access seems to be going alright, but for some bizarre reason i can't send/receive email without a synch error (will have to see if this relates to the Palm SMS Threader app though).
thanks guys.

Can't understand this internet problem.

Hi
I flashed the
WM6 Cingular USA version (same as the official but cingular customized and radio version 1.48) thanx madcap180
http://rapidshare.com/files/42972317...T-MR3_Ship.exe last night without any problems. But after that I am having trouble of connecting to internet.
Detais: I was connecting internet at home via my own WIFI router well before I flashed the ROM. But afterwards, I can logon skype, and use check windows updates. However, I cannot use IE to go to any webpage. Also, I cannot logon windows live messager. They just simply resposnes that "The page cannot be dispalyed or downloaded because the connection was lost. check the connection and try again later." But the connection is fine all the time.
Can somebody help?
Thanks
Never mind. fixed. just disable the proxy
I too am on at&t usa and every time I experience problems with internet access I simply hard reset and load the "cingular" settings cab. This way your setting are pre configured and it works everytime. The only other thing I could recommend is checking your connection settings under connections and of course email as well . Beyond this, I dunno maybe try and load another rom.

I Get "HTTP ERROR: $CODES$" accesing T-Mobile Internet

My Internet connection was working fine... then I installed Meschle's WM6.1 Touch, which I like very much...
... but I lost the ability to reach the Internet. All my settings are correct for a WAP connection to T-Mobile, I tried it with and without a proxy, I tried changing ports on the proxy... but I keep getting the HTTP ERROR message regardless of what changes I make. It happens on any and all sites.
I know the GPRS connection is made, because after that the browser shows the "locating..connecting..opening" sequence... and then the error.
Help !
same here
this has been happening on my brothers phone for some time. I have tried 3 different roms and 2 tmobile settings as well as the network wizzard. Any fix out there? One rom actually after the setup wizzard let him connect for a few hours now this is back.
first call the T-mobile and ask them if the service is activated for you.
and try to delete all settings and then see this post it may help you
http://forum.xda-developers.com/showthread.php?p=2237367#post2237367

Mobile Internet connection dropping

Hi guys, after installing the latest radio on my Hero I get the feeling that my mobile internet connection (both HSDPA, 3G and 2G) seem to be dropping more often than before. I haven't monitored this prior to upgrades so I can't say for sure. But is anybody having the same experience?
Also is it possible to downgrade the radio? Do you just reinstall the old radio?
Thanks.
yes i have the same issue. my mobile internet and also the gps stops to work after a while of not using the phone. i have to restart the phone to get gps back to work.
mobile internet can also be reactivated by activating and deactivating the "only 2g networks" option.
this failure sucks because i just recognize that the mobile internet is down because i didn't get push mails for a while.
I have noticed that as well
Yep me too. I can be browsing (web, market, or rss) for a while, then lose connection for a bit, then it will suddenly work again.
Can we reflash the old radio?
No need. It could be the APN settings. I was having problems on T-Mobile with HSDPA dropping and read in another post to go to the T-Mobile support page for the G2 and select Connecting to the Internet --> Set up the phone for internet surfing --> and follow the instuctions to set up a new APN. Worked for me
I have the same problem.
I have installed the new Hero ROM two weeks ago, one week ago mobile internet disappeared from my phone. Before this it was very good.
I can't find the good solution for this issue. Please help.
Same radio ROM. But there were internet for a week with this ROM.
I don't understand.
(I have tried to reflash the ROM, but not solved.)
Same problem here.
Mobile network has been unstable since I bought it.
When I turn it off for a while and turn it on again, I can't see the icon on the top bar. What I have to do is going to Settings - Wireless controls - Mobile network settings - Network operators - Select automatically.
Sometimes the connection is lost while using. I have to do the same thing like above to make it work again.
I also contacted HTC's customer service, but I haven't got any response.
Too bad!
I find if I leave it then it comes back. Every so often it goes...then the firmware eventually notices and it reconnects. Annoying. Hopefully this will be fixed when T-Mobile release thier version of the ROM update later this week.
I have the same issue, but it seems like it only happens when I leave a wirelss-zone (and not every time I do that either).
When I leave home, it will maybe 1 of 3 times not connect to 3G before I manually connect again (Settings - Wireless controls - Mobile network settings - Network operators - Select automatically)
I've just used AnyCut to create a shortcut to this menu-option so it is less annoying, but a more permanent and official fix would be great.
same thing in my one thats why i hate htc from now one loots of bugs in hero headphones led net go back to htc hd how you can release phone if is not done properly
TheBrit said:
No need. It could be the APN settings. I was having problems on T-Mobile with HSDPA dropping and read in another post to go to the T-Mobile support page for the G2 and select Connecting to the Internet --> Set up the phone for internet surfing --> and follow the instuctions to set up a new APN. Worked for me
Click to expand...
Click to collapse
TheBrit's settings appear to have resolved the issue. have been logged into instant messenger for more than an hour without the connection dropping off give it a go guys.
wow, how much better is that
Guys, if u have the dropping connection concern, as I did, please follow tmobile link in previous posts or a one for your mobile provide apn settings, I've just done it and have had no dropped connections for ages
i was also having the same issue but since installing the modoco 2.6 enhanced rom with the radio ending in 07.08 all has been good.
dropping connection
Hi,
I have a g2 Touch from T-Mobile germany.
It runs Runs modaco 2.6 with the newest Radio. Dont know the number it ends on 0708.
I have the prob with dopping connections. But i cant download the settings from tmo germany, because there are no settings to download. Can anyone help me? Or Can i flash the old Radio back? And where can i get it for tmo germany?
Volker

res://ieframe.dll/NoRadioWifiOff.htm

Hello, i am new inn the forum and new with WP/ terminals.
I have now a HTC HD7 surround, i am from Argentina, and my cellphone company is Claro Argentina.
My HTC is free from factory (at&t) , so any SIM is running well, but i have a navigation problem:
I can´t browse the web with 3G, i can via WIFI, but not 3G.
I have a iPhone 4 2, and i can browse the web with that phone and same SIM.
I already added differents APN´s and downloaded the Connection Setup via Marketplace.
I reseted the phone 3 times
The problem still here.
when i try to use the IE, in the navigation bar, i type some address, and after less than 1 second i see this :
res://ieframe.dll/NoRadioWifiOff.htm
Click to expand...
Click to collapse
And then, a page saying:
We´re having trouble
reaching this webpage.
-------------------------
You have might lost your cellular data
connection.
etc etc etc...
I cant navigate via 3G, I CAN via Wi Fi.
Any help ?
Thanks in advance.
nocive
Hello man, I have exactly the same problem with a LG E900 with Windows Phone 7, the phone was bought from Spain (Movistar), everything is fine except 3G.
Did you find the solution for this?
does 3g works at all or are you having problems only with IE?
go to the dignotic page
Intall the diagnotic app and look at post #150
http://forum.xda-developers.com/showthread.php?t=839154
Hi sandrobber, I have a LG Optimus 7 and the same problem, the wifi and EDGE and Wifi works without problem, I've checked and my mobile operator uses 850UMTS band for 3G and the phone works with that band, I've set the correct APN but I still without 3G and EDGE really sucks!
I've check the post #150 in http://forum.xda-developers.com/showthread.php?t=839154 but I can't find any place to use these codes in order to set up my 3G automatically, that codes works with my LG Phone? How can I enter those codes?
I will really appreciate your help.
Vitucho
I have the same problem too, and mostly on EDGE... I have to restart the phone to get it working again... Very frustrating if you tell me.
LOL, now that you all say that , I have the same problem to.
I need to turn off 3G if I want to have an internet conection.
did you all flash some rom's on the phone ?
ceesheim said:
LOL, now that you all say that , I have the same problem to.
I need to turn off 3G if I want to have an internet conection.
did you all flash some rom's on the phone ?
Click to expand...
Click to collapse
The thing is, I don't have 3G 2100 in the country I live in
I can only rely on EDGE, so activating/deactivating 3G is useless for me.
I didn't flash. Just upgraded to 7392 two weeks ago.
I'm looking for a way to completely reset the network stack (equivalent to a reset) in order to re-establish a fresh connection.
My old Nokia E63 with the same SIM card had no problem establishing data. The only problem was the sometimes, the connection was really slow to attach (something like 15 seconds). I therefore suspect that WP7 phones have a too stringent timeout problem, i.e. the phone gives up trying to establish a connection after a failed first attempt (the phone didn't wait long enough).
I am thinking of just reflashing only the radio rom from a stock o2 rom (I have o2 Germany)
ceesheim said:
I am thinking of just reflashing only the radio rom from a stock o2 rom (I have o2 Germany)
Click to expand...
Click to collapse
Yeah you can try that. I have the gut feeling that it's firmware-dependant. If someone can try with the latest Samsung FW that's been posted recently... I'm a bit lazy to lose all my settings

Categories

Resources